Joint FAA – EASA Workshop
Qualification / Verification of Additively Manufactured Parts
September 17 – 19, 2024

Wichita State University - Rhatigan Student Center
1845 Fairmount St, Wichita, KS 67260

Add to Calendar    Tentative Agenda    Invitation Letter

The Federal Aviation Administration (FAA) is pleased to host the Joint EASA-FAA Workshop on Additive Manufacturing 2024 at the National Institute of Aviation Research (NIAR) in Wichita, KS from September 17-19, 2024. The Workshop is co-hosted by the European Aviation Safety Agency (EASA) and represents continuation of the by-invitation, face-to-face format resumed in 2023.

The Workshop will span three days of open session presentations and discussions, complimented by separate focus topic working group meetings. Continuation of working groups from prior Workshops is planned, i.e. WG1: Qualification of Additive Manufacturing (AM) Parts of No, or Low Criticality, WG2: Fatigue and Damage Tolerance/NDE for Metal AM and WG3: Machine Monitoring – Developing a Five-Year Plan to Allow EASA/FAA Acceptance. Consideration of an additional focus topic working group for part classification is underway; check back here for further developments.

 

Recommended Hotel:
Hyatt Place @ Wichita State
4703 E 19th St N
(316) 364-4700
Request the WSU-NIAR rate
Book   Additional Hotels


Registration 

Please provide your initial working group preference.*
This selection is for planning purposes only and you will be able to change your working group during the event.